Signal Flow Through PARIS Mixer including Auxes and Master/Global sections.


Manual (see below for Edmund's ASCII correction)

Mixer signal flow

Signal flow through an individual mixer strip.


Signal Flow

Ok, I'll tell you this: native inserts come BEFORE the EDS inserts, below
is the corrected flow diagram:

>
>
>

> PLAYBACK
>

>
>
> WAVE READ FROM DISK
> |
> NATIVE INSERTS (top to bottom)
> |
> EDS INSERTS (top to bottom)
> |
> TRIM
> |
> EQ MODULE
> |
> PHASE switch
> |
> LEVEL METER/CLIP INDICATOR (if show meters as post is unchecked)
> |
> AUX TAP POINT (PRE)
> |
> FADER
> |
> MUTE BUTTON
> |
> LEVEL METER/CLIP INDICATOR (if show meters as post is checked)
> |
> AUX TAP POINT (P/P)
> |
> PAN
> |
> AUX TAP POINT (POST)
> |
>
> | |
> | SOLO
> | |
> ST. SUBMIX BUS MONITOR BUS

This is pretty close, but no warranties are made. Trim and EQ are done in
one step (so the separation above is not quite correct).


Edmund Pirali
Intelligent Devices, Inc.

There are no comments on this page. [Add comment]

Valid XHTML 1.0 Transitional :: Valid CSS :: Powered by WikkaWiki