Revision [1130]
This is an old revision of NowLineSlop made by admin on 2008-11-01 12:36:52.
Paris Positions Slightly Inaccurate
2. WHICH BAR POSITION READOUT SHOULD I BELIEVE
>
> Unless i'm doing something wrong, it would seem that the bar
> position readout is not totaly accurate. When i SHIFT click the
> now line to the start of a bar, for example bar 73. The readout
> on the BAR/BEATS ruler should read 73/1/000. Instead it reads
> something like 73/1/003 or 73/1/005. If you then zoom in all the
> way and move the now line to exactly 73/1/000 and cut the part it
> will cut to a different position, usually a measure of 001 or 002
> to the left of the now line. While these measurements may not seem
> much they make a hugh difference to timing. Whenever you move
> parts and snap them to grid bar/beats or them selves, they move
> out of time.
(answer:) You can ignore the small offset. It is correct, because PARIS requires an
80 samples grid to mix 16 and 24 bit files in a project, and that is the
small offset. We will relax this in the future.
Back to BugsTroubleshooting Bugs and Troubleshooting
