====Paris Positions Slightly Inaccurate====

//WHICH BAR POSITION READOUT SHOULD I BELIEVE?
Unless i'm doing something wrong, it would seem that the bar
position readout is not totaly accurate. When i SHIFT click the
now line to the start of a bar, for example bar 73. The readout
on the BAR/BEATS ruler should read 73/1/000. Instead it reads
something like 73/1/003 or 73/1/005. If you then zoom in all the
way and move the now line to exactly 73/1/000 and cut the part it
will cut to a different position, usually a measure of 001 or 002
to the left of the now line. While these measurements may not seem
much they make a hugh difference to timing. Whenever you move
parts and snap them to grid bar/beats or them selves, they move
out of time.//

//**(answer:)** You can ignore the small offset. It is correct, because PARIS requires an
80 samples grid to mix 16 and 24 bit files in a project, and that is the
small offset. We will relax this in the future.//


----
Back to [[BugsTroubleshooting Bugs and Troubleshooting]]