Supplying Aux FX (ie reverb) to Individual Headphone Mixes using Auxes
Just a brief note until a detailed step-by-step can be created - this one's done entirely from memory, it's been a long time
- take the outputs from one of your Auxes (eg Aux 8)
- patch them back into one or two mixer channels (depending on stereo or mono)
- the wet signal from the Aux can now be routed to headphones like any other signal.
Caution, don't route it to *itself* (ie if you're using the output from Aux 8 to feed a strip, never turn up Aux 8 on that strip) as this will cause it to feed back potentially causing serious speaker damage.
